User's Guide
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- 4 | Setup for Palm
- 5 | Setup for Windows XP
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CHS
- STEP 5: Scan Data into Your Application
- Assigning Sound and Prefix/Suffix Settings
- Configuring Advanced Bluetooth Settings
- Assigning a Trigger Button
- Selecting Symbologies
- Viewing Version Information
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- Appendix E Decode Zone
- Appendix F Troubleshooting
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
STEP 4: START SOCKETSCAN AND CONNECT TO CHS
1. If you did not install Connect!Agent start your computer’s Bluetooth
software and make sure the Bluetooth radio is turned on.
2. Right-click the SocketScan icon at the bottom of the screen and click
Connect CS.
If you installed Connect!Agent, it will automatically open the Bluetooth
software and turn on the Bluetooth radio when you click Connect CS.
After you configure the correct Bluetooth hardware settings in
SocketScan, the Connect CS menu option allows you to connect to the
CHS directly from SocketScan, instead of manually connecting via
your Bluetooth software.
The Connect CS option will not appear unless you checked the box
Enable CS Support in the SocketScanXP settings.
SocketScan will not be able to connect to the CHS if you have another
device assigned as your favorite or default Bluetooth serial device.
3. If you are using Connect!Agent, and this is your first time connecting,
Connect!Agent will automatically begin searching for the CHS. After it
finds the CHS, it will automatically configure the connection.
4. SocketScan will connect the computer to the CHS,
indicated by a beep and a status bubble.
CHAPTER 4: SETUP FOR WINDOWS XP 51