User's Guide
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- 4 | Setup for Palm
- 5 | Setup for Windows XP
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CHS
- STEP 5: Scan Data into Your Application
- Assigning Sound and Prefix/Suffix Settings
- Configuring Advanced Bluetooth Settings
- Assigning a Trigger Button
- Selecting Symbologies
- Viewing Version Information
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- Appendix E Decode Zone
- Appendix F Troubleshooting
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
STEP 3: CONFIGURE SCANNER SETTINGS
1. Click the SocketScan icon at the bottom of the screen. In the pop-up
menu, click Settings.
Alternatively, click Start | Control Panel | SocketScanXP Settings.
2. Tap on the CS tab. Enter the following settings:
• Enable CS support: Check this box. IMPORTANT!!!
• Enable ActivePairing: This feature is not compatible with the CHS. Do
not check the box.
• Bluetooth stack: Select Socket (Connect!Agent) if you want to use it.
Otherwise, select your computer’s Bluetooth stack. The
Connect!Agent option will only appear if you installed the
Connect!Agent software.
CHAPTER 4: SETUP FOR WINDOWS XP 49