User's Guide
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- 4 | Setup for Palm
- 5 | Setup for Windows XP
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CHS
- STEP 5: Scan Data into Your Application
- Assigning Sound and Prefix/Suffix Settings
- Configuring Advanced Bluetooth Settings
- Assigning a Trigger Button
- Selecting Symbologies
- Viewing Version Information
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- Appendix E Decode Zone
- Appendix F Troubleshooting
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
Toshiba Bluetooth Stack:
These instructions are based on a Motion Computing tablet. Refer to the manual
for your Bluetooth hardware/software for specific Bluetooth usage instructions.
1. Turn on the Bluetooth radio of your computer. Tap on the Dashboard icon
on the desktop. In the dashboard, check Enable Internal Bluetooth Wireless
Radio. Tap OK.
2. Turn on the Cordless Hand Scanner. Press the small power button for five
seconds, until you see the LED turn blue. The LED should blink blue once
per second to show that the Bluetooth radio is on but not connected.
3. Double-tap on the Bluetooth icon at the bottom of your screen.
4. In Bluetooth Settings, tap New Connection at the bottom of the screen.
5. The Add New Connection Wizard will launch. Select Custom Mode and
tap Next. The tablet will begin searching for Bluetooth devices in range.
46