User's Guide
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- 4 | Setup for Palm
- 5 | Setup for Windows XP
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CHS
- STEP 5: Scan Data into Your Application
- Assigning Sound and Prefix/Suffix Settings
- Configuring Advanced Bluetooth Settings
- Assigning a Trigger Button
- Selecting Symbologies
- Viewing Version Information
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- Appendix E Decode Zone
- Appendix F Troubleshooting
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
CONFIGURING SCAN SETTINGS
1. Make sure the main screen of SocketScan reports that the CHS is
enabled. Tap Configure.
You can configure prefix/suffixes whether or not the CHS is
connected to your device.
2. The Configure screen will appear. Enter any settings, as desired:
• Trigger Mode: Select Local to directly trigger the scanner whenever
you press the trigger button. Select Remote to have the scanner
verify a connection to your PDA before it activates the laser.
• Read Indicator: Select how you would like the CHS to indicate that
data was successfully decoded and transmitted to the PDA.
• Auto reconnect to last device: Check to have your PDA automatically
connect to the last CHS unit it connected to whenever you tap
Enabled in the main screen of SocketScan.
• Keep PDA alive for: Select how long you would like the PDA to stay
alive after the last scan. This feature allows you to scan data for
several hours without touching the PDA, as long as you scan at least
once before the time limit passes. Select System Default to keep your
PDA alive for the amount of time set as default in the PDA’s system
settings.
36