User's Guide
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- 4 | Setup for Palm
- 5 | Setup for Windows XP
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CHS
- STEP 5: Scan Data into Your Application
- Assigning Sound and Prefix/Suffix Settings
- Configuring Advanced Bluetooth Settings
- Assigning a Trigger Button
- Selecting Symbologies
- Viewing Version Information
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- Appendix E Decode Zone
- Appendix F Troubleshooting
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
3. After a successful scan, data should appear in your document. For
example, after you scan a bar code into a Memo, data should appear in
the first line. The default “CR” (carriage return) suffix will advance the
cursor to the next line, ready for the next scan.
Wait for the “Good Scan” indication before you scan another bar code.
If you try to scan too fast, the device can lock up until you stop
scanning.
For information about bar code scanning applications for asset tracking,
health care and other vertical markets, please visit:
www.socketmobile.com/solutions/vertical-markets/
CHAPTER 3: SETUP FOR PALM 35