User's Guide
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- 4 | Setup for Palm
- 5 | Setup for Windows XP
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CHS
- STEP 5: Scan Data into Your Application
- Assigning Sound and Prefix/Suffix Settings
- Configuring Advanced Bluetooth Settings
- Assigning a Trigger Button
- Selecting Symbologies
- Viewing Version Information
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- Appendix E Decode Zone
- Appendix F Troubleshooting
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
8. When the scanner connects to your device, the CHS will beep once. The
main screen of SocketScan will also indicate that the scanner is enabled,
and the Configure, Symbologies, and Test buttons will appear at the
bottom of the screen.
If the PDA suspends, the CHS will automatically re-connect
once you turn on the PDA again.
If the CHS is taken out of range, or if the Bluetooth connection
is otherwise lost, to resume operation you must enable it again
in SocketScan.
For more information about the meanings of LEDs and beeps,
please see page 9.
CHAPTER 3: SETUP FOR PALM 33