User's Guide
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- 4 | Setup for Palm
- 5 | Setup for Windows XP
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CHS
- STEP 5: Scan Data into Your Application
- Assigning Sound and Prefix/Suffix Settings
- Configuring Advanced Bluetooth Settings
- Assigning a Trigger Button
- Selecting Symbologies
- Viewing Version Information
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- Appendix E Decode Zone
- Appendix F Troubleshooting
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
STEP 2: CONNECT CHS TO PDA WITH BLUETOOTH
**SocketScan supports a generic Bluetooth COM port and may be able to
connect to Bluetooth stacks on host mobile computers other than those
listed.
1. Turn on the Cordless Hand Scanner. Press the
small power button for five seconds, until you
see the LED turn blue. The LED should blink blue
once every second to show that the Bluetooth radio
is on but not connected. If the LED begins
blinking red, the battery needs to be recharged.
2. Start SocketScan. Tap Home. In the upper right
corner, make sure All is selected. Scroll down and tap on the SocketScan
icon.
3. The main screen of SocketScan will appear, showing a picture of the
Socket SDIO In-Hand Scan Card. In the Scanner Device drop-down
menu, select Bluetooth CHS.
4. The screen will display a picture of the Cordless Hand Scanner. In the
Device is field, tap Enabled.
CHAPTER 3: SETUP FOR PALM 31