User's Guide
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- 4 | Setup for Palm
- 5 | Setup for Windows XP
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CHS
- STEP 5: Scan Data into Your Application
- Assigning Sound and Prefix/Suffix Settings
- Configuring Advanced Bluetooth Settings
- Assigning a Trigger Button
- Selecting Symbologies
- Viewing Version Information
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- Appendix E Decode Zone
- Appendix F Troubleshooting
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
STEP 1: INSTALL THE SOFTWARE
1. Delete any bar code scanning software already installed in your device,
including previous versions of SocketScan. Make sure the software is
closed. Tap Home, then tap Menu. In the App menu, tap Delete. Use the
utility to delete the software.
2. Use HotSync and a serial/USB cable or cradle to connect your device to
a host PC.
3. Insert the installation CD into your host PC.
4. Use My Computer or Windows Explorer to access your CD drive.
5. In the CD, open the SocketScanPalm folder and click on Setup.
6. The SocketScan Installation program will begin. Follow the instructions
on your screen to install the software.
7. When software installation is complete, disconnect the device from the
host PC. Soft reset the device by pressing the reset button.
30