User's Guide
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- 4 | Setup for Palm
- 5 | Setup for Windows XP
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CHS
- STEP 5: Scan Data into Your Application
- Assigning Sound and Prefix/Suffix Settings
- Configuring Advanced Bluetooth Settings
- Assigning a Trigger Button
- Selecting Symbologies
- Viewing Version Information
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- Appendix E Decode Zone
- Appendix F Troubleshooting
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
4 | SETUP FOR PALM
This chapter explains how to install and use the
Cordless Hand Scanner (CHS) with a Bluetooth
enabled device running Palm OS 5.2 or later.
Before you begin the instructions in this chapter,
make sure you have installed the batteries (and
tether, if desired), and charged the scanner, as
described in Chapter 2, “Hardware Setup.”
SETUP SUMMARY
STEP 1: Install the software.
STEP 2: Connect scanner to PDA with Bluetooth.
STEP 3: Scan data into your application.
Configuring scan settings.
Selecting symbologies.
Testing bar codes.
For help using SocketScan, tap on the
button on the top of
any screen.
CHAPTER 3: SETUP FOR PALM 29