User's Guide
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- 4 | Setup for Palm
- 5 | Setup for Windows XP
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CHS
- STEP 5: Scan Data into Your Application
- Assigning Sound and Prefix/Suffix Settings
- Configuring Advanced Bluetooth Settings
- Assigning a Trigger Button
- Selecting Symbologies
- Viewing Version Information
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- Appendix E Decode Zone
- Appendix F Troubleshooting
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
USING THE CONNECT!AGENT UTILITY
The Connect!Agent utility enables you to view and change the default
Cordless Hand Scanner, Cordless Ring Scanner or Cordless 56K Modem
that Connect!Agent will attempt to connect to.
1. Tap Start | Settings | System tab | Connect!Agent.
2. The Connect!Agent utility lists the wireless bar code scanners and/or
modems that it has saved as favorite devices. These are specific devices
that Connect!Agent automatically attempts to connect to whenever
SocketScan or a Bluetooth dial-up connection is initiated.
CHAPTER 2: SETUP FOR WINDOWS MOBILE 27