User's Guide
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- 4 | Setup for Palm
- 5 | Setup for Windows XP
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CHS
- STEP 5: Scan Data into Your Application
- Assigning Sound and Prefix/Suffix Settings
- Configuring Advanced Bluetooth Settings
- Assigning a Trigger Button
- Selecting Symbologies
- Viewing Version Information
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- Appendix E Decode Zone
- Appendix F Troubleshooting
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
CONFIGURING SOUNDS
The SocketScan applet lets you specify sounds used to indicate when the
CHS has successfully scanned data and transmitted it to the host device.
1. Tap on the SocketScan icon. In the pop-up menu, tap Settings.
You can configure sounds whether or not the CHS is connected
to your Pocket PC.
2. The Scanner Settings utility will appear, with the Prefix/Suffix tab open.
Tap on the Sound tab.
3. Select which sound you want your mobile computer to use to indicate a
good read.
If you select Play .wav file, tap on the … button to search for the .wav file
you want to use (the file must be located in the My Documents folder).
Tap ok.
CHAPTER 2: SETUP FOR WINDOWS MOBILE 25