User's Guide
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- 4 | Setup for Palm
- 5 | Setup for Windows XP
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CHS
- STEP 5: Scan Data into Your Application
- Assigning Sound and Prefix/Suffix Settings
- Configuring Advanced Bluetooth Settings
- Assigning a Trigger Button
- Selecting Symbologies
- Viewing Version Information
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- Appendix E Decode Zone
- Appendix F Troubleshooting
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
For information about third-party applications compatible with the CHS
for asset tracking, health care, and other vertical markets, visit:
www.socketmobile.com/solutions/vertical-markets/
Reconnecting
If your mobile device suspends or the CHS moves out of range, the
connection will end. After the mobile device turns on again or returns in
range, SocketScan will try to re-connect 3 times. If, after 3 attempts,
they have not re-connected, you will need to manually re-connect them.
Disconnecting
To disconnect, tap on the SocketScan icon at the bottom of the Today
screen and tap Disconnect. Your mobile device will disconnect from the
CHS, and Connect!Agent will turn off the Bluetooth radio of your
mobile device.
Turning off the CHS
To turn off the CHS, press the power button at least 2 seconds, until the
LED stops blinking.
22