User's Guide
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- 4 | Setup for Palm
- 5 | Setup for Windows XP
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CHS
- STEP 5: Scan Data into Your Application
- Assigning Sound and Prefix/Suffix Settings
- Configuring Advanced Bluetooth Settings
- Assigning a Trigger Button
- Selecting Symbologies
- Viewing Version Information
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- Appendix E Decode Zone
- Appendix F Troubleshooting
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
- If you have previously connected to a CHS or CRS, Connect!Agent
will automatically begin searching for your favorite (default)
device.
5. If Connect!Agent does not have a favorite scanner and finds multiple
CHS and/or CRS devices in range, select the one you want to connect to
and tap ok.
To help you identify the scanner, Connect!Agent reports the scanner’s
Bluetooth MAC address. The characters in brackets are the last six
characters of the address.
CHAPTER 2: SETUP FOR WINDOWS MOBILE 19