User's Guide
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- 4 | Setup for Palm
- 5 | Setup for Windows XP
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CHS
- STEP 5: Scan Data into Your Application
- Assigning Sound and Prefix/Suffix Settings
- Configuring Advanced Bluetooth Settings
- Assigning a Trigger Button
- Selecting Symbologies
- Viewing Version Information
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- Appendix E Decode Zone
- Appendix F Troubleshooting
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
6. Tap on the CS HW tab.
Enter the following settings:
• Trigger: Select whether you would like the CHS to scan only when a
Bluetooth connection to the device is detected. If you require the
CHS to detect a Bluetooth connection before each scan, scanning
will be a few milliseconds slower.
• Good Read Indicator: Select how you would like the CHS to indicate
that it has successfully read data.
• Battery Level: No progress bar should appear since you are not
connected to the CHS.
• Disable Auto Power Off mode: The CHS automatically shuts off if
there is no Bluetooth connection for 20 minutes. Check to disable.
7. After entering settings, tap ok to save the changes.
CHAPTER 2: SETUP FOR WINDOWS MOBILE 17