User's Guide
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- 4 | Setup for Palm
- 5 | Setup for Windows XP
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CHS
- STEP 5: Scan Data into Your Application
- Assigning Sound and Prefix/Suffix Settings
- Configuring Advanced Bluetooth Settings
- Assigning a Trigger Button
- Selecting Symbologies
- Viewing Version Information
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- Appendix E Decode Zone
- Appendix F Troubleshooting
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
7. After installing the software, a dialog on your Pocket PC will direct
you to soft reset. Tap ok.
8. Remove your device from the cable/cradle and perform a soft reset by
pressing the reset button. If you skip this step, some icons may not
appear correctly.
9. Install Connect!Agent by opening the Connect!Agent folder in the CD
and clicking on Connect!AgentSetup.exe. Follow the wizard to install the
software.
CHAPTER 2: SETUP FOR WINDOWS MOBILE 15