User's Guide
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- 4 | Setup for Palm
- 5 | Setup for Windows XP
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CHS
- STEP 5: Scan Data into Your Application
- Assigning Sound and Prefix/Suffix Settings
- Configuring Advanced Bluetooth Settings
- Assigning a Trigger Button
- Selecting Symbologies
- Viewing Version Information
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- Appendix E Decode Zone
- Appendix F Troubleshooting
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
3 | SETUP FOR WINDOWS MOBILE
This chapter explains how to install and use the
Cordless Hand Scanner (CHS) with a Bluetooth
enabled Pocket PC or other mobile computing device
running Windows Mobile 2003, 2003SE or 5.0.
Before you begin the instructions in this chapter,
make sure you have installed the batteries (and tether,
if desired), and charged the scanner, as described in
Chapter 2, “Hardware Preparation.”
SETUP SUMMARY
STEP 1: Install the software.
STEP 2: Configure scanner settings.
STEP 3: Connect scanner to host device with Bluetooth.
STEP 4: Scan data into your application.
Selecting symbologies
Configuring prefixes/suffixes
Configuring sounds
Running Scan Demo
Using the Connect!Agent Utility
CHAPTER 2: SETUP FOR WINDOWS MOBILE 13