User's Manual
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | General Installation
- 3 | Dial-up Networking
- 4 | Bluetooth ActiveSync and LAN Access
- 5 | Socket OBEX
- 6 | Socket Dialer
- 7 | Bluetooth Serial Port
- 8 | Bluetooth Faxing and Printing
- 9 | My Device Manager
- 10 | Bluetooth Devices Folder
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Troubleshooting
- Appendix D Technical Support
- Limited Warranty
- Regulatory Compliance
8. In the next screen, enter the User name and Password. Tap Advanced…
9. In the General screen, enter the following settings:
• Baud rate: 115200
• Wait for dial tone before dialing: Uncheck
Unchec
k
10. The next step varies depending on if your network uses DHCP or a
static IP address.
• If your network uses DHCP, tap ok. In the last screen, tap Finish.
• If you need to enter IP addresses, tap on the TCP/IP and Servers tabs
to enter the necessary settings. Tap ok. In the last screen, tap Finish.
Now you have finished creating a connection and are ready to dial up to
your network. Socket recommends using either of two methods for dialing
in and connecting to your network.
CHAPTER 3: DIAL-UP NETWORKING | 23