User's Manual
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Setup for the SoMo®
- 3 | SocketScan Plug-in Software
- 4 | RFID Demo
- Appendix A Product Specifications
- Appendix B HF RFID Standards and Tag Descriptions
- Appendix C Barcode Label Specifications
- Appendix D Enabling or Disabling Symbologies
- Appendix E Laser Decode Zone
- Appendix F Troubleshooting
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
42
PicoTag
Inside Contactless (formerly Inside Technologies) makes a contactless RFID product
series called the PicoTag. There are two different sizes of PicoTag memories, 2K and
16K. There are two different modes of operation, plain and secure.
Figure 9 - Memory Structure of the PicoTag 2K
29 blocks of 8 bytes = 232 bytes (1856 bits) of user memory is available for
read/write.
Block #
64 bits
(8 bytes per block)
3 (0x03)
4 (0x04)
5 (0x05)
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
30 (0x1E)
31 (0x1F)
The user can
permanently
lock any block
Once a block is
locked it can not
be unlocked.
A 64-bit ID (factory programmed) uniquely identifies each PicoTag chip.
TID Unique Tag ID 64 bits (8 bytes)
Note: Only the tag ID can be read by the SOMO 655 RFID Reader-Scan Card.