User's Manual
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Setup for the SoMo®
- 3 | SocketScan Plug-in Software
- 4 | RFID Demo
- Appendix A Product Specifications
- Appendix B HF RFID Standards and Tag Descriptions
- Appendix C Barcode Label Specifications
- Appendix D Enabling or Disabling Symbologies
- Appendix E Laser Decode Zone
- Appendix F Troubleshooting
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
4. In the Sound screen, select which sound you would like SocketScan Plug-
in to make to indicate a good read.
To you want to play a .WAV file, after selecting Play .wav file, you can
search through files by tapping the browse box. In the Open screen, tap
on the file you want:
Note: You can only select a WAV file from the My Documents folder. If
needed, copy the file you need to this folder.
5. After selecting your sound, tap on the RFID tab.
6. In the RFID screen, enter the following settings:
Trigger mode:
Tag ID Only: Select to read only the tag ID.
Read Data Only: Select to read only data from the tag memory.
20