User's Manual
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Setup for the SoMo®
- 3 | SocketScan Plug-in Software
- 4 | RFID Demo
- Appendix A Product Specifications
- Appendix B HF RFID Standards and Tag Descriptions
- Appendix C Barcode Label Specifications
- Appendix D Enabling or Disabling Symbologies
- Appendix E Laser Decode Zone
- Appendix F Troubleshooting
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
When data is read, a beep should sound indicating a good read, and data should
appear in your application.
For example, in an Excel Mobile spreadsheet, data should appear in the cell you
highlighted. The next cell should now be highlighted, ready for the next scan/read.
If the card fails to read data within a few seconds, you must try again.
Note: By default, the RFID reader will return the tag ID. The RFID Setup utility can
be used so that the RFID Reader-Scan Card returns only the tag data, or the tag
ID plus the tag data. (See the next page for instructions.)
CHAPTER 2: SETUP FOR THE SOMO 17