User's Manual
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Setup for the SoMo®
- 3 | SocketScan Plug-in Software
- 4 | RFID Demo
- Appendix A Product Specifications
- Appendix B HF RFID Standards and Tag Descriptions
- Appendix C Barcode Label Specifications
- Appendix D Enabling or Disabling Symbologies
- Appendix E Laser Decode Zone
- Appendix F Troubleshooting
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
STEP 5: Read Data into Your Application
Please note that the correct positions for RFID reading and barcode
scanning are very different!
CORRECT RFID POSITION:
Hold the card parallel to and directly above the tag, at most
3.0 inches above the tag.
Parallel,
3.0 inches (7.6 cm)
max
imum
N
ote: The LED will turn amber to indicate that the card is reading tag IDs.
CORRECT BARCODE SCANNING POSITION:
CHAPTER 2: SETUP FOR THE SOMO 15
Hold the card so that the lens is angled about 45° to the
barcode and at least 2.0 inches away from the barcode. The
red laser line should cover the entire width of the barcode.
Note: The proper scanning distance and angle vary depending on the size, type,
quality, and print surface of the barcode.