User's Manual
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Setup for the SoMo®
- 3 | SocketScan Plug-in Software
- 4 | RFID Demo
- Appendix A Product Specifications
- Appendix B HF RFID Standards and Tag Descriptions
- Appendix C Barcode Label Specifications
- Appendix D Enabling or Disabling Symbologies
- Appendix E Laser Decode Zone
- Appendix F Troubleshooting
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
STEP 2: Start SocketScan Plug-in
1. If you assigned a hardware button to SocketScan Plug-in, you can
press the button to quickly launch the program. Otherwise, tap Start
| Programs | SocketScan Plug-in folder | SocketScan Plug-in.
2. An icon will appear in the task tray of the Today screen indicating that the
system does not detect the RFID reader.
When SocketScan Plug-in is running, any of the following icons will appear in the
task tray of the Today screen:
Icon Meaning.
Card detected, RFID mode. SocketScan Plug-in detects the card and is ready
to read RFID tags.
Card detected, scanning mode. SocketScan Plug-in detects the card and is
ready to read barcodes.
No RFID Reader Card detected. The reader card is either missing or
improperly inserted.
STEP 3: Insert the Card
1. Open the card slot cover on top of the SoMo.
2. Insert the card into the CompactFlash slot. Make sure the card is right-side up,
with the blue label on top. Push the card all the way into the slot.
CHAPTER 2: SETUP FOR THE SOMO 13