User's Manual
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Setup for the SoMo®
- 3 | SocketScan Plug-in Software
- 4 | RFID Demo
- Appendix A Product Specifications
- Appendix B HF RFID Standards and Tag Descriptions
- Appendix C Barcode Label Specifications
- Appendix D Enabling or Disabling Symbologies
- Appendix E Laser Decode Zone
- Appendix F Troubleshooting
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
Windows Mobile 5
Please refer to the chart below to determine which SocketScan Plug-in functions you
would like to assign to buttons on your device.
Note: If you have the SOMO 655 RFID Reader-Scan Card 6P2, SocketScan Plug-in allows
you to configure up to four buttons for launching SocketScan Plug-in and/or
triggering the RFID reader or barcode scanner.
Program
What happens when you press a button assigned to this
program?
If SocketScan Plug-in is not open, SocketScan Plug-in will launch.
If SocketScan Plug-in is open and you have the SOMO 655 RFID Reader Card
6E2/6E2Rx, the RFID reader will activate.
If SocketScan Plug-in is open and you have the SOMO 655 RFID Reader-Scan
Card 6P2, either the RFID reader or the laser scanner will activate,
depending on which mode the card is in.
If you assign only one hardware button for use with the SOMO 655
RFID Reader Card, this is the program that should be assigned.
If you do not assign a button to SocketScan Plug-in, you can only start
SocketScan Plug-in by manually tapping through menus.
If you are using the SOMO 655 RFID Reader-Scan Card 6P2, this program
will switch the device from RFID mode to barcode scanning mode, or vice
versa. This is designed to be used with a trigger button assigned to
SocketScan Plug-in. You can also use Socket Trigger Select to toggle to
other Socket Mobile barcode scanners that use a software trigger.
The laser bar ode scanner will activate. SocketScan Plug-in must be running.
The RFID reader will activate. SocketScan Plug-in must be running.
CHAPTER 2: SETUP FOR THE SOMO 11