User Manual
Table Of Contents
- Overview
- Hardware Description
- System Requirements
- Desktop Test Set-up
- Hardware Configuration
- WinCE Test Setup
- HCI Test Setup
- Suspend\Resume
- Bluetooth Driver List
- Certification Testing Utilities
- KwikBlue Development Board Jumpers
- Audio CODEC Setup (Optional)
- KwikBlue Development Board Bill of Materials (BOM)
- CODEC Board Bill of Materials (BOM)
- Errata
- Appendix A: BC01 vs. BC02 Pin Assignments
KwikBlue Module Development Kit Installation Guide
BC02 Class 2 Module Pin Assignments
Signal Name Function Direction Pin #
GROUND Power supply return 1
PCM_OUT Serial data from audio CODEC IN 2
PCM_IN Serial data to audio CODEC OUT 3
PIO_1 Generic I/O local host OUT 4
PIO_4 Generic I/O local host RS232 (DTR) OUT 5
UART_RXD Serial data from local host RS232 (RXD) IN 6
UART_TXD Serial data to local host RS232 (TXD) OUT 7
RESET Reset module when HIGH IN 8
PIO_3 Generic I/O local host RS232 (DSR) IN 9
SPI_CSB SPI chip select IN 10
GROUND Power supply return 11
UART_RTS Local host must not send when HIGH OUT 12
SPI_CLK SPI Clock IN 13
UART_CTS Module must not send when HIGH IN 14
PCM_SYNC Audio CODEC signal OUT 15
PIO_2 Generic I/O local host RS232 (DCD) IN 16
SPI_MOSI SPI master out slave in IN 17
PCM_CLK Audio CODEC signal OUT 18
SPI_MISO SPI master in slave out OUT 19
VCC_3.3V Power supply 20
Table 8: BC02 Class 2 Module Pin Assignments
April 23, 2004 Copyright © 2003-2004 Socket Communications, Inc. Page 25
Document#: 6410-00215-C CONFIDENTIAL Revision 1.04