User Manual
Table Of Contents
- Overview
- Hardware Description
- System Requirements
- Desktop Test Set-up
- Hardware Configuration
- WinCE Test Setup
- HCI Test Setup
- Suspend\Resume
- Bluetooth Driver List
- Certification Testing Utilities
- KwikBlue Development Board Jumpers
- Audio CODEC Setup (Optional)
- KwikBlue Development Board Bill of Materials (BOM)
- CODEC Board Bill of Materials (BOM)
- Errata
- Appendix A: BC01 vs. BC02 Pin Assignments
KwikBlue Module Development Kit Installation Guide
Regulatory Compliance
The KwikBlue-1 Class 1 Module using Bluetooth wireless technology complies with Part 15 of the FCC
Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the user will be required to
correct the interference at their own expense.
This equipment generates and radiates radio-frequency energy. To comply with FCC RF exposure
compliance requirements, the following antenna installation and device operation configurations must be
satisfied: (1) Users are not permitted to make changes or modify the system in any way, and (2)
connecting external antennas to the card is prohibited. Changes or modifications not expressly approved
by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: For end-users of the KwikBlue-1 Class 1 Module, the FCC ID# LUBBTM-2 must be displayed
on the outside of the host, i.e., “Contains FCC ID: LUBBTM-2.”
April 23, 2004 Copyright © 2003-2004 Socket Communications, Inc. Page iii
Document#: 6410-00215-C CONFIDENTIAL Revision 1.04