User Manual
Table Of Contents
- Overview
- Hardware Description
- System Requirements
- Desktop Test Set-up
- Hardware Configuration
- WinCE Test Setup
- HCI Test Setup
- Suspend\Resume
- Bluetooth Driver List
- Certification Testing Utilities
- KwikBlue Development Board Jumpers
- Audio CODEC Setup (Optional)
- KwikBlue Development Board Bill of Materials (BOM)
- CODEC Board Bill of Materials (BOM)
- Errata
- Appendix A: BC01 vs. BC02 Pin Assignments
KwikBlue Module Development Kit Installation Guide
12. Audio CODEC Setup (Optional)
Figure 8: Optional Audio CODEC Board Setup
Setting up the CODEC board:
Using 10-pin ribbon cable, connect CODEC JP1 to KwikBlue Development Board connector
JP1.
Connect headphone/microphone to CODEC connector J9.
Connect 5 VDC power supply to KwikBlue development board connector J4
April 23, 2004 Copyright © 2003-2004 Socket Communications, Inc. Page 19
Document#: 6410-00215-C CONFIDENTIAL Revision 1.04