User Manual
Table Of Contents
- Overview
- Hardware Description
- System Requirements
- Desktop Test Set-up
- Hardware Configuration
- WinCE Test Setup
- HCI Test Setup
- Suspend\Resume
- Bluetooth Driver List
- Certification Testing Utilities
- KwikBlue Development Board Jumpers
- Audio CODEC Setup (Optional)
- KwikBlue Development Board Bill of Materials (BOM)
- CODEC Board Bill of Materials (BOM)
- Errata
- Appendix A: BC01 vs. BC02 Pin Assignments
KwikBlue Module Development Kit Installation Guide
d) The KwikBlue Serial Card Wizard, KwikBlueWizard.exe, is installed to the “C:\Program
Files\Socket KwikBlue” directory. A shortcut should be available from the Start, Programs menu
of your device. Run the KwikBlue Serial Card Wizard. From the drop-down menu, select “Serial
Card KwikBlue at 115K”:
Serial Card KwikBlue at 115 Kbps - This is the default module configuration and sets the
Bluetooth drivers to work with a module programmed at 115200 bps.
Serial Card KwikBlue at 921 Kbps - This configures the Bluetooth drivers to work with a
module programmed at 921600 bps.
NOTE: Do not install the Serial drivers from the Serial I/O High Speed Driver Installation Disc.
This will overwrite the Serial card Bluetooth configuration settings.
e) Reset your device.
f) Assemble KwikBlue Development Board components:
Figure 7: HCI Test - KwikBlue Development Board Set-up
April 23, 2004 Copyright © 2003-2004 Socket Communications, Inc. Page 13
Document#: 6410-00215-C CONFIDENTIAL Revision 1.04