Technical Manual

Bluetooth Raw Serial Module Technical Specification

Document#: 6410-00195 A Revision 0.7

D1<Inquiry_Scan_Interval>,< Inquiry_Scan_Window><CR>

Default: 4096,18

Example:

“D11024,512<CR>”

Note:

To enable scanning the values for Interval and Window must be in the range of 18 to

4096. The Window value must be less than the Interval value. Both values must be

zero to disable scanning.

Inquiry scan timing is described in the Bluetooth V1.1 Core Specifications for up to

date information see: http://www.bluetoothsig.org/specifications.htm

6.3.11. Set Encryption/Authentication: "PIN CODE"

S4<PIN code>

PIN code – Pin code can be NULL and as long as 16 characters

Default: NULL PIN code

Example:

“S4MyPinCode <CR>”

Note:

6.3.12. Set Connectable Device Bluetooth Address

This command forces the Module to only allow only the device of the specified Bluetooth

address to connect to it. This value is saved in the module until RESET by this command.

Note: A value of "000000000000" means allow any device to connect.

S5<BDADDR>

BDADDR – Bluetooth device address of device that will be allowed to connect

Default: %00%00%00%00%00%00

Example:

“S5%01%00%55%0C%00%1B <CR>”

Note: