User Manual
Table Of Contents
- How this Manual is Organized
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 Basic Setup
- Chapter 3 Advanced Features
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Troubleshooting
- I cannot connect to a device in my folder.
- When I try to connect to my phone, I get a screen that says Partial Success.
- When I insert the Bluetooth Card, I get a message that says Unrecognized Card.
- My mobile computer cannot find any Bluetooth devices nearby.
- My mobile computer keeps powering down to protect memory contents.
- Appendix D Technical Support
- Limited Warranty
- Limited Software Warranty
- Copyright Notice
- Regulatory Compliance
CHAPTER 2 BASIC SETUP | 11
4. When the search is complete, a screen will list the discovered Bluetooth
phones. Choose the phone you wish to connect to, and tap Select.
A service discovery phase will begin, about 10-15 seconds.
5. As prompted in the next screen, set your phone to “Bondable” or
“Pairable” mode. For instructions, refer to your phone manual.
Have your passkey ready, then tap Next>.
6. In the next screen, enter the passkey. Tap Reply.
7. Enter the same passkey into your mobile phone. Your mobile phone
may automatically display a message asking for your passkey, or it may
automatically accept the passkey entered.
8. In the next screen, tap Finish. After successfully connecting, the phone
will appear in your Bluetooth Devices folder.
Note: Exchanging passkeys allows your phone and mobile computer to set
up an encrypted data link to provide you a secure communication path.