User's Manual
Table Of Contents
- Copyright Notice
- _
- 1 | Introduction
- Socket Go Wi-Fi!
- Socket Wi-Fi Companion
- System Requirements
- Product Registration
- Useful Links
- 2 | Software Installation
- _
- 3 | Open or WEP-Enabled Networks
- 4 | WPA or 802.1x Networks
- 5 | Wi-Fi Companion
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Network Information
- _
- _
- Appendix D Troubleshooting
- _
- _
- Appendix E Technical Support
- _
CHAPTER 4: WPA OR 802.1X 29
2. Follow the appropriate instructions for your type of network to enter the
necessary security settings.
WPA Networks
¾ Network Key tab
• Authentication: Select the correct WPA
type, either WPA or WPA-PSK.
If using WPA-PSK, also enter the Network
key. The key length must be either 64 hex
or 8-63 ASCII characters.
• Data Encryption: Select TKIP.
¾ 802.1x tab
• Use IEEE 802.1x network access control:
Check.
• EAP Type: Select the type of EAP
authentication used by your network,
either PEAP or Smart Card or Certificate
(EAP-TLS)
When done, tap ok.