User's Manual
Table Of Contents
- Table of Contents
- 1 | Introduction
- Back
- Front
- 2 | Getting Started
- STEP 1: Install the Battery
- STEP 2: Charge the Battery
- STEP 3: Set up your SoMo 655
- STEP 4: Install Synchronization Software on Host PC
- STEP 5: Connect to Host Computer
- STEP 6: Set Up Your Device Partnership
- Windows 7/Vista
- Windows XP/2000
- Register SoMo 655
- Install Microsoft Windows Mobile Updates
- Set up Enhanced Wi-Fi Companion
- Set up SocketScan 10
- Configure A/B Mode Switch
- Set up Connect!Agent
- Sprite Backup Trial
- MobiScan Rapid Configuration Tool
- Set up Data Capture Triggers
- Set up WAN Connections
- Configure CF/SD slots
- 3 | Using the SoMo 655
- 4 | Wi-Fi Companion
- 5 | Socketscan 10 for CHS Series 7 Barcode Scanners
- 6 | Socketscan Plug-In for Scanners and Readers
- Appendix A
- Appendix B
- Appendix C
- Appendix E
- Appendix F
- Limited Warranty
- Disclaimer
- Limited Software Warranty
- Regulatory Compliance
29
Configure CF/SD slots
In most cases you will not need to use this utility. If you insert a memory card into the SoMo and cannot
access data from the card after the device suspends/resumes, use the utility to leave the card slot enabled
even when the device has suspended.
1. In the list of Getting Started wizards, tap Configure CF/SD slots.
2. Check the appropriate box to enable a card slot after the SoMo suspends/ resumes.
3. Tap OK.
CAUTION: ONLY LEAVE A SLOT ENABLED TO INSERT A MEMORY CARD. DO NOT LEAVE A
SLOT ENABLED TO INSERT A SOCKET CF / SD DEVICE OR OTHER I/O CARD.
LEAVING A SLOT ENABLED WHEN THE SOMO IS NOT IN USE CAN DEPLETE THE BATTERY.
IF YOU LEAVE A SLOT ENABLED WHEN THE SOMO IS POWERED ON, DO NOT REMOVE OR
INSERT A CARD UNLESS IT IS A MEMORY CARD.