Kite Assembly instruction Kit components 123456- SoaringModels 2019 Wing Fuselage Fin Stabilizer Rod tubes Accessories Accessories components 1234567- T-peg Servo covers Aileron’s rods Tail torsions Aileron’s horns Stabilizer horn Fin horn 8910111213- 1 Connector Connector’s mount for fuselage Wing screws M3*10, M3*12 Tail screws M3*6 Crimping tubes for tail rods Tail rods
Kite Assembly instruction Recommended electronic components SoaringModels 2019 1- Battery 1S 250-350 mAh 2- KST X-08H *2 + Dymond D-47 *2 or KST X-08H *2 + KST X-08 *2 3- Receiver 4-8 channels 4- 400 mm servo wires 22 AWG Tools and materials for assembling 12345678- Ruler Files Sand paper Knife Soldering iron Cyanoacrylate Epoxy Two-side tape 2
Kite Assembly instruction Mounting of control horns SoaringModels 2019 Cut the slots for the control horns and aileron rods with a knife according to the pictures. In rudder on the right side in the middle. In elevator at the top side. In ailerons at the distance of 50 mm from center of the wing.
Kite Assembly instruction SoaringModels 2019 File out control horns before gluing. Paste in control horns using epoxy.
Kite Assembly instruction T-peg installation SoaringModels 2019 Prepare t-peg for gluing using file Make a slot for peg using knife, file and wire.
Kite Assembly instruction Servos installation SoaringModels 2019 Clean pockets from foam Mark hole position on aileron’s rod, ailerons should be 8-9mm down and servos in zero position. Bend the rod.
Kite Assembly instruction Soldering ailerons connector SoaringModels 2019 Make holes for wires in core from servos pockets to connector pocket. Cut original connectors (don’t forget to setup zero position before) and lay the wires through holes to connector pocket.
Kite Assembly instruction If you don’t use servo frame add foam or balsa for total servos fixing SoaringModels 2019 If you use servo frames for KST X-08H glue it with epoxy to the pockets and fix servos with screws Fix servo covers with two-side tape 8
Kite Assembly instruction Fuselage assembling SoaringModels 2019 Make holes for wires and tubes Glue servos for tail with 26mm from forward of fuselage Lay rods through fuselage, put tubes on rods and glue them in holes of fuselage. Fix rods with tape temporary.
Kite Assembly instruction Lay extension into fuselage. SoaringModels 2019 Glue mount part to connector, keep movable parts from glue! Set connector into fuselage and check contact with wing. Make corrections with slot for connector with file if it needs. Glue connector’s mount part to fuselage.
Kite Assembly instruction File out place for tail boom on fin surface SoaringModels 2019 Insert fin into slot in tail boom set it vertically and fix with cyanoacrylate 11
Kite Assembly instruction Set neutral position of tail servos, rudder and elevator. SoaringModels 2019 Crimp tube on cable.
Kite Assembly instruction Settings and flight modes SoaringModels 2019 Recommended CG position 74-78mm from leading edge Launch mode – ailerons 1mm up Cruise - 0 Normal flight – 2mm down Thermal – 4-9mm down Brakes – maximum down 13
