Record Player MODEL: LPSC-025 Instruction Manual PLEASE READ THIS MANUAL CAREFULLY BEFORE USE AND KEEP IT FOR FUTURE REFERENCE
BEFORE USE 1. Choose a safe location and avoid placing the unit in direct sunlight or near any heat source. 2. Avoid environments subject to vibration, excessive dust, cold or moisture. 3. Due to the risk of electrical shock, do not open the cabinet. Should a foreign object accidentally find its way into the interior of the unit, contact your local dealer. 4. Do not attempt to clean the unit with chemical solvents as this might damage the finishing. A clean, dry cloth is recommended for cleaning. 5.
2. Anti-skating Knob 3. Lift Lever 4. Tonearm 5. Mode Switch Button 6. Volume Control Button 7. AUTO STOP Switch Button 8. 33/45 RPM Speed Switch Button 9. Stylus/Needle Cartridge—Audio Technica AT-3600L MM cartridge 10. Turntable Shaft 11. External Speaker Clips 12. L/R RCA Output Jack—to connect other external amplifier or speaker system 13. DC IN Power Jack 14. Power Switch 15. Speaker Set 16.
vinyl records, it will stop when it does not come to the end, or it will not stop when it comes to the end when AUTO STOP is ON. 6.Turn the VOLUME CONTROL KNOB to adjust the volume. Bluetooth Mode 1. Press up the MODE button to BT mode. The LED light indicator becomes blue with flashing. 2. Turn on your Bluetooth function on your mobile phone or tablet PC and then search the turntable player with its name LPSC-025.
TIPS FOR BETTER TURNTABLE PERFORMANCE 1. When opening or closing the turntable cover, handle it gently, gripping it either at the centre or at each side. 2. Do not touch the needle tip with your fingers; avoid bumping the needle against the turntable platter or record edge. 3. Gently wipe the dust cover and turntable housing with a soft cloth. Use only a small amount of mild detergent to clean the turntable and dust cover. 4. Never apply harsh chemicals or solvents to any part of the turntable system.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.