User Manual

Lit. No. 70445, Rev. 03 16 July 15, 2018
OPERATING THE SPREADER – CAB CONTROL
Setup Codes
Code Defi nition Procedure
Cb Calibrate the Empty Hopper setting. With control in ON mode, press and hold the left control knob until the
Cb code displays. Calibration cycle is automatic.*
Cc Clear calibration data for Empty Hopper
setting; clear EH code.
Press the right control knob to clear all calibration data during the
calibration cycle.
LS Set LED brightness level. With control in Ready mode, press and hold left control knob to get
LS code. Release pressure and turn left control knob to desired
brightness setting. Wait for confi rming SL code to display.*
SL Confi rms that LED brightness level has
been reset.
* For full instructions, see the "Setup Procedures" section.
Information Codes
Code Defi nition Response
Ar Auto-reverse sequence is active (auger
only).
The spreader will automatically detect and attempt to clear a jam. See
the Operating the Spreader section of this manual.
dU Not applicable to tailgate spreaders.
Possibly indicates a harness or
module issue.
Contact authorized dealer.
EH Empty hopper (beep will sound). Check hopper for material.
Recalibrate Empty Hopper setting as described above for Cb code.
Lb Low battery. Hopper module is sensing
<10V. (Lb becomes an error code
when module senses <6V.)
Refer to the Lb row under "Error Codes" (next page).
CAB CONTROL CODES
Table continues on next page.
Error Codes – Spreader Operation Stopped
Code Defi nition Possible Cause Suggested Solution
bb Bad button. Button is stuck.
Button was pressed while
vehicle ignition was entering
ACC or START mode.
Possible harness issue.
Inspect control. Free up button.
Do not press any spreader cab control buttons
while the vehicle ignition is being engaged.
Check connections and integrity of vehicle
harness.
bH Bad hopper. Possible module or control
mismatch.
Replace control or module. Use only genuine
service parts. Contact authorized dealer.
CE No communication with
spreader module.
Loose connection.
Module lost power.
Confi rm that spreader and control harnesses are
connected to the vehicle harness. Check power
to spreader module, all connections, fuses, and
power studs. Check that port B is plugged into
the module.
CF Control malfunction. Control is overheating.
May be a combination of faults.
Inspect connections at spreader module, hopper
drive motor, and spinner drive motor.