User Manual

Lit. No. 70445, Rev. 03 15 July 15, 2018
Ready Mode
Vehicle ignition is set to ACC or ON; cab control is OFF.
Control has power. Spreader is detected.
The Material Width control knob can be set to start-up
conditions, but the spinner will not operate until the
cab control is turned ON.
(Accessory lights and vibrator are operational.) The
BLAST function is not operational.
ON Mode
Vehicle ignition is set to ACC or ON; cab control is ON.
Spinner motor will start. All cab control functions
are operational. (Accessory lights and vibrator are
operational.)
During normal spreader operation no control codes are
displayed. Information or setup codes will appear when
relevant. These codes will not stop spreader operation.
Error Mode
When an error condition occurs, spreader operation
will shut down. A two-digit error code will fl ash on the
display and a beep will sound. If there are multiple error
codes, the codes will fl ash in a repeating sequence.
Refer to the Error Codes portion of the
following Cab Control Codes table. Also see the
Troubleshooting Guide section of this manual.
Once the error condition has been resolved, press the
ON/OFF button to clear the error code(s). Press the
ON/OFF button again to resume spreader operation.
The error code will reappear if the error condition
has not been rectifi ed. If the error condition persists,
contact your authorized dealer.
Multiple resets within a short time frame will cause
the hopper module to time out if components are
overheating. The control will display an EF error code.
Accessory work lights and AUX 1 can be used when
an error code is in effect, and will remain in their
current state. The vibrator and AUX 2 will not function.
OPERATING THE SPREADER – CAB CONTROL
CONTROLLING MATERIAL APPLICATION
The material application settings can be adjusted
while spreader is ON or OFF. Settings are shown by
the indicator lights around the control knob. When the
spreader is OFF, a single LED will light to show the
current setting. When the spreader is ON, the number
of blue LEDs illuminated will increase/decrease as the
knob is turned clockwise/counterclockwise.
The Material Width knob controls spinner speed.
Turning the knob clockwise will increase the width of
the application area.
Turning the control knob counterclockwise will
decrease the width of the application area.
BLAST/Maximum Application
1. Press and hold the BLAST button when maximum
application area is needed temporarily. The
BLAST button will illuminate while depressed.
2. Release the button when maximum application
settings are no longer needed.
NOTE: Spinner speed reverts to the previous
settings once the BLAST button is released.
CAB CONTROL MODES
Standby Mode
Vehicle ignition is set to ACC or ON; cab control is
OFF. Control has power. No spreader was detected.
No lights are illuminated on the control. Press any
button to wake.