User Manual

ManualsBrandsSnowEx ManualsCarPMT-175-C

BUMPER PLATE SPACER FOR BUMPER OBSTRUCTION

ON CHEVROLET VEHICLES

.ytQ noitpircseD

.oN traP

yeK

.ytQ noitpircseD

.oN traP

yeK

D 4116 1/2-13 x 1-1/2” Hex Bolt

1/2” Flat Washer

1/2” Lock Nut

3/8-16 x 1” Hex Bolt

3/8-16 x 1-1/2” Hex Bolt

3/8 Lock Nut

3/8 Flat Washer

5/16 Lock Nut

5/16-18 x 2” Hex Bolt

1/2” Toggle

1/2-13 x 3” Hex Bolt Full Thread

Bed Rail Bracket Right

Bed Rail Bracket Left

Pivot Tube Assembly

Angle Top

Pivot Bumper Bracket

Latch Bumper Bracket

Pivot Channel Assembly

Latch Channel Assembly

Rubber Tip Protector

D 4119

D 4120

D 4121

D 4122

D 4124

D 4125

D 6138

D 6139

D 6141

D 6144

D 6200

D 6201

D 6202

D 6203

D 6204

D 6205

D 6206

D 6207

D 6208

1/2-13 x 4” Hex Bolt Full Thread

1/8” x 2-1/16” Hair Pin Clip

2 2

D 6142

D 6222

1/2-13 x 1-1/4” Hex Bolt

Latch Bar

3 1

D 6143

D 6223

NOTE:

When installing the Pivot Mount, if any movement is

noted with Rail Brackets due to weakened or altered

conditions of pick-up bed, drill and bolt through

pre-punched Rail Brackets to assure rm mounting.

Pivot Mount Parts Breakdown

Model #PMT-175-C (For GM and Chevrolet 2007 Models and Newer 2500 HD and Larger)

Chevolet Plastic Spacer Block

2D 6739

NOTE:

PMT-175-C kit is the same as

the PMT-175 kit except for item

# 25 spacer.

Summary of content (3 pages)

PAGE 1
Pivot Mount Parts Breakdown Model #PMT-175-C (For GM and Chevrolet 2007 Models and Newer 2500 HD and Larger) NOTE: When installing the Pivot Mount, if any movement is noted with Rail Brackets due to weakened or altered conditions of pick-up bed, drill and bolt through pre-punched Rail Brackets to assure firm mounting. NOTE: PMT-175-C kit is the same as the PMT-175 kit except for item # 25 spacer. BUMPER PLATE SPACER FOR BUMPER OBSTRUCTION ON CHEVROLET VEHICLES Key Par t No.
PAGE 2
Pivot Mount Installation Instructions Model #PMT-175 Step 1: Insert upper & lower pivot rails into main frame of spreader. Line up the pre-punched holes on the pivot rail with the main frame, then bolt together. Holes are pre-determined and can be relocated if spreader is not centered on vehicle. Step 2: Locate top bed rail mounting brackets and set on top of pickup bed rails; Center by moving out towards the bumper. maintain a minimum of 2” clearance between tailgate and spreader.
PAGE 3
Pivot Mount Installation Diagrams Model #PMT-175 / PMT-175-C Fig. A Fig. B Fig. C Part Must Remain Straight When Tightening NO D A C N A G U E T R I O NO N See Step 4A Fig. D Fig. E Fig. F Cut bar to length Drill hole Drill and install bolt w/lock nut Fig. G Fig. H Fig.