Operator`s manual

2. Place the spool cover on the spool and press it rmly
down until the locking devices of the spool cover securely
click into place (Fig. 15).
Check length of nylon cutting line
1. Pull the line to the inner edge of the outer safety guard. If
the line is too short (i.e. less than 50 mm from the inside
edge of the safety guard), push down on the center of
the trimmer head and simultaneously pull the line a few
centimeters past the edge of the safety guard (Fig. 16).
To increase line length
NOTE: The grass trimmer comes with a full line spool. The line
wears down during work. To feed in new line:
1. Switch the machine on and press the head of the spool
rmly against the ground.
2. The line will automatically be released by centrifugal force.
The trimmer line will be cut to the right length by the blade
on the spool cover.
Operation
The Electric Grass Trimmer/Edger is designed to cut grass
and weeds under bushes, and on slopes and edges that
cannot be reached with the lawn mower. The trimmer must
be used outdoors only, at an ambient temperature between
0ºC and 45ºC.
mWARNING! Remove stones, loose pieces of wood
and other objects from the cutting area. The blade continues
to rotate for a few seconds after the trimmer is switched off.
Let the motor come to a complete stop before switching the
trimmer back on. Do not rapidly switch the trimmer off and on.
ON/OFF switch
1. To switch the grass trimmer ON, press and hold the safety
button, then squeeze the ON/OFF trigger and release the
safety button.
2. To switch OFF, release the ON/OFF trigger.
Cutting grass
1. Move the grass trimmer left and right, keeping it a safe
distance away from the body. The trimmer can efciently
cut grass up to a height of 6 in. (15 cm). Cut higher grass
in stages.
2. When using the trimmer, hold it at an angle of about 20°
to the ground (Fig. 17) and swing the trimmer from side to
side (Fig. 18).
Fig. 15
Locking
devices
Spool
Spool cover
Fig. 16
Spool
Outer guard
Center of trimmer head
20°
Fig. 17
8