Replacement Part List

Replacing the Scraper Bar

1. The scraper bar is located at the base of the snow thrower

beneath the rotor housing (Fig. 30).

2. Remove the screws that secure the scraper to the snow

thrower (Fig. 31).

3. Install the new scraper bar and fasten it securely to the

snow thrower with the screws.

Replacing the Belt

NOTE: Under normal operating conditions, it should not be

necessary to replace the auger belt. However, should the auger

jam or malfunction, the belt could be damaged. To replace the

belt, follow the instructions.

NOTE: Determine the left and right hand side of the snow

thrower by standing behind the unit in the normal operating

position.

1. Open the left side plate by removing the 4 screws

(Fig. 32).

2. Use your right hand to turn the rib side of the belt

up and pull upwards while turning the auger pulley

counterclockwise with your left hand. The belt can be

easily removed from the pulley (Fig. 33).

3. Put the belt on the drive pulley rst and then place the

belt at the lower end of the auger pulley (Fig. 34).

Fig. 30

Scraper bar

Fig. 31

The screws that secure the scraper bar

Fig. 32

Screws

Fig. 33

Belt

Fig. 34

Auger pulley

Drive

pulley