Operator`s manual

13. Check that the electrical supply voltage and frequency
(Volt/Hz) correspond to those specied on the washer
rating plate. If the power supply is correct, you may now
plug the washer into the power outlet (Fig. 16).
Operation
m
IMPORTANT! This pressure washer is equipped with
a micro-switch sensitive to water ow. This Total Stop System
(TSS) senses water ow in the pump. When the trigger is
released, water stops owing through the pump. The TSS then
automatically turns the motor off to protect the pump from
overheating.
1. Turn the water supply tap on completely.
2. Release the safety lock, then press the trigger for a few
seconds until water ow is steady to allow air to escape
and to discharge residual pressure in the hose
(Figs. 17 and 18).
3. Keeping the trigger pressed, turn the switch to the ON (1)
position to start the pressure washer.
4. When re-starting the motor, always keep the trigger
pressed.
NOTE: The motor only runs when the trigger is operated
and shuts off when the trigger is released.
Using the accessories
mWARNING! High pressure jets can be dangerous if
subject to misuse. The jet must not be directed at persons,
pets, live electrical equipment or the appliance itself.
• The washer is equipped with an adjustable nozzle.
• The water pressure can be adjusted from low pressure (–) to
high pressure (+) by turning the pressure adjustment knob.
(Fig. 19).
• The nozzle tip can be adjusted from stream (wide open tip)
to fan (narrow tip) by turning the nozzle tip adjustment knob
as indicated by the directional arrows (Fig. 19).
mWARNING! Do not adjust the nozzle while the trigger
is squeezed. Failure to do so could result in damage.
Fig. 16
GFCI
Fig. 17
Trigger
Safety lock
Fig. 18
Fig. 19
Stream
Fan
Nozzle tip
Pressure adjustment knob
Nozzle tip
adjustment knob
Close
O
p
e
n
8