MSDS

3
Section 7: Preventive Measures
Specic Engineering controls required ----------------- Local exhaust for dust
Procedures to be followed in case of spill/leak ----------------- Small spills:May be ushed away with water or sweep up.
Large spils: Sweep or scoop up for reuse or disposal.
Waste Disposal ----------------- Small spills: May be sewered.
Large spills: Should be disposed of in landll according
to regulations.
Protective Equipment to be used ----------------- While this product is considered non-hazardous, good
industrial practice suggests the use of proper eye
protection and the use of gloves.
Storage Needs ----------------- Store away from strong oxidizing agents.
Handling procedures and equipment ----------------- Store in dry area. Keep container closed.
Special shipping information ----------------- Not applicable
Section 8: First Aid Measures
EYE CONTACT ----------------- Flush eyes with owing water. If irritation or redness
are severe or persist, consult physician.
SKIN CONTACT ----------------- Flush skin with running water.
INGESTION ----------------- Drink liquids to dilute and consult physician
INHALATION ----------------- Move victim to fresh air
Section 9: Preparation Information
Prepared by ----------------- Quality Assurance Department
Emergency Phone No. ----------------- [phone] (Canutec)
Date ----------------- September 2014
The information is, to the best of our knowledge and belief, accurate and reliable as of the date compiled. However, no
representation, warranty or guarantee is made to its accuracy, reliability or completeness. It is the user’s responsibility to review
this information, satisfy themselves as to its suitability and completeness and pass on the information to its employees or
customers. Kissner Salt & Chemicals does not accept responsibility for any loss or damage which may occur from the use of this
information.