Replacement Part List

5. Use the drive speed control lever, adjust the speed for a

comfortable pace (Fig. 24).

IMPORTANT! Drive speed can be changed without stopping

the snow blower.

Stopping the Machine

1. Release the auger trigger. Drive motor and auger will both

stop (Fig. 25).

2. Wait for all moving parts to come to a complete stop.

3. Remove the batteries.

Reverse Traveling

Be careful when moving backward with the snow blower.

Always look down and behind before backing up. For safety

reasons, the machine cannot throw snow when moving

backward. When auger trigger is activated during reverse

travelling, the machine will exit the reverse mode and stop.

1. Before backing up, stop the machine by release both

triggers and wait until all movement come to a complete

stop.

2. Press the reverse button, the reverse indicator LED will

light up to indicate that the machine is in reverse mode

(Fig. 26).

3. Squeeze drive trigger against the right-handle and the

snow blower will move backward (Fig. 26).

4. During backing up, pay attention not to squeeze the auger

trigger. The snow blower will stop if auger is triggered

during back up. If this happens, release both triggers and

press the reverse button again to restart backing up.

NOTE: When the reverse button is pressed, the reverse mode

is activated for 15 seconds. If the drive trigger is not squeezed

within 15 seconds, the snow blower will exit the reverse mode.

Fig. 23

Drive trigger

(Right-handle)

Fig. 24

Drive speed

control lever

Fig. 25

Auger trigger

(Left-handle)

Fig. 26

Press the reverse button

Squeeze the drive trigger