Replacement Part List
15
5. Retighten hex nuts securely.
Pre-Start
1. Charge batteries – See Charger Operation section on
page 10.
2. Check function of triggers – If triggers cannot engage or
disengage properly, adjust or repair before operation.
3. Check Skid Shoes – Check and adjust skid shoes.
Emergency Stop
Immediately release both triggers to stop unit in an emergency.
Wait for all rotating parts to stop before leaving operator’s
position.
Operation
mWARNING! Failure to follow instructions could result
in personal injury and/or damage to snow blower. DO NOT
attempt to start your snow blower at this time. Read entire
operator manual rst.
See page 12 for all controls and features.
mWARNING! Keep the area to be cleared free of stones,
toys or other foreign objects that the rotor blades might pick
up and throw. Such items could be covered by snow and are
easy to overlook, so be sure to conduct a thorough inspection
of the area before beginning work.
Starting the Machine
IMPORTANT! Make sure both triggers are released before
inserting the battery packs.
1. Open the battery compartment cover and slide two battery
packs down until they both click and lock into position
(Fig. 20). Close the cover.
2. Flip up the safety switch, then squeeze the auger trigger
against the left-handle (Fig. 21). The auger will start
rotating and plowing snow.
NOTE: Auger trigger should be engaged before drive trigger
when throwing snow.
3. Use the auger speed control lever to set a comfortable
plowing speed (Fig. 22).
IMPORTANT! DO NOT overload unit capacity by attempting to
clear snow at too fast a rate. Use slow speed to clear deep or
hard packed snow.
4. Squeeze drive trigger against the right-handle and the
snow blower will move (Fig. 23). When the blower is
moving steadily, you can release the drive trigger while
keep the auger trigger squeezed to maintain the snow
blower's movement. Release the auger trigger and both
the drive motion and plow motion will stop.
Fig. 20
Battery compartment cover
Battery packs
Fig. 21
Flip up the safety
switch
1
Squeeze the
auger trigger
2
Fig. 22
Auger speed
control lever