Operator`s manual

2. Before assembling and decorating your tree, check to
make sure that the tree stand works properly by plugging
a light set into one of the three electrical receptacles
located on the spindle (Fig. 7). Flip the LIGHT and ROTATE
switches located on the control box to the ON position
(Fig. 8). The lights should light up and the spindle should
start rotating. Flipping the LIGHT and ROTATE switches to
the OFF position should likewise turn off these respective
functions.
3. Assemble, light and decorate your tree.
4. This tree stand is rated for a maximum of 8 Amps (960
Watts) at 120 Volts, AC 60 Hz. This typically corresponds
to 2,400 lights for 50 or 100 miniature light sets; 1,680
lights for 35 or 70 miniature light sets. Double check
manufacturer’s label on light sets before plugging them
into the tree stand.
Note: Plug a maximum of 3 miniature light sets together
end-to-end and a maximum of 2 cool burn C7 light sets
together end-to-end. Use a UL listed extension cord if
necessary to reach maximum number of lights.
m WARNING m
Damaged electric cords present risk of re,
electrical shock and serious bodily injury.
• Before operating this tree stand, carefully examine
its electrical cord. If the cord is damaged, do not
use this tree stand. Instead, promptly inform the
dealer where you bought the tree stand or contact
Snow Joe Customer Service (1-866-766-9563).
• Before lighting your tree, carefully inspect the light
strings for frayed wires, damaged sockets and
worn plugs. If any damage is seen or suspected, do
not use.
A
A
C
B
B
B
C
A
C
D
Figure 7
A. Receptacle
B. Spindle Screws (x3)
C. Collar Screws (x3)
D. Rotating Power Base
LIGHT
ON
OFF
ROTATE
ON
OFF
A
B
C
D
Figure 8
A. Reset Switch
B. Switch Box
C. Light Switch
D. Rotation Switch
m WARNING m
Carefully read and follow all manufacturers’
instructions for the light sets, extension cords,
trees and decorations you wish to use.
• Use only UL or ETL listed light sets and extension
cords.
• Inspect all light sets for wear and damage. If any
damage is seen or suspected, do not use.
4