Operator`s manual
3
3. Slide the collar down the pole and secure it to the tree
stand by fastening the three (3) collar screws (Fig. 4).
IMPORTANT: Do not over-tighten the screws, since this
can damage the tree stand.
4. Tighten all three (3) spindle screws to secure the tree in a
stable, upright position (Fig. 5).
5. Make sure the tree ts securely inside the collar before
turning on the tree stand. Once the tree is installed inside
the stand, do not rock it back and forth since this can
damage the stand. If the tree does not t properly even
after tightening the collar screws, please contact Snow
Joe Customer Service at 1-866-766-9563.
Operation
1. The electric cord has a polarized plug (Fig. 6), with one
prong slightly longer and wider than the other. This plug
can be inserted only one way into a polarized outlet. If the
plug does not t properly in the outlet, unplug it from the
outlet and insert it in the reverse direction. If it still does
not t, seek the assistance of a qualied electrician.
Note: If using an extension cord with this unit, make sure
that the original plug ts snugly into the extension cord
slots, which are likewise polarized.
A
E
D
C
B
B
Figure 4
A. Articial Tree Pole
B. Collar Screws (x3)
C. Tree Base Collar
D. Rotating Power Base
E. Tree Stand Base
A
B
B
B
C
D
Figure 5
A. Articial Tree Pole
B. Spindle Screws (x3)
C. Rotating Power Base
D. Receptacle
m WARNING m
Electric shock can cause SEVERE INJURY or
DEATH. Heed these warnings:
• Do not allow any part of tree stand to make contact
with water while powered on. If the stand becomes
wet while turned off, wipe dry before starting.
• Do not touch the tree stand or its plug with wet
hands or while standing in water.
• Do not use with an extension cord unless the plug
can be fully inserted.
A
Figure 6
A. Electrical Cord