Warranty

30SB, 36SB, 45SB

Snow BEAST

Snow BEAST Snow Blower

Rev Sept 2019

Check & Replacing the Transmission Drive Belt

If belt needs to be changed or altered for any reason, the

belt is located in the front of the snow blower behind the

discharge chute and in front of the wheels.

1. Remove the cover that is protecting the snow

blower’s belts. Remove the screws and simply lift

up the cover.

2. Remove the black belt and replace with a new belt.

3. Attach the cover and all hardware as they were

when taken off.

IMPORTANT! The snow blower belts are adjusted to

ensure the augers stop turning within 5 seconds of

releasing the augers/impeller control lever. If you are

making any belt adjustments whatsoever, for your safety

and the safety of others around you, you must ensure the

belts are re-adjusted to achieve this design speciﬁcation.

Check & Replacing the Augers/Impeller Belt

There are two located in the front of the snow blower

behind the discharge chute and in front of the wheels.

1. Remove the cover that is protecting the Snow

Beast’s belts. Remove the screws and simply lift up

the cover.

2. Remove the two belts and replace with new belt or

belts depending on the belt’s condition.

3. Attach the cover and all parts as they were when

taken off.

NOTE: Always change both belts at the same time.

Changing only one belt can lead to performance issues.

Also check for correct belt tension after changing belts.

Readjust if necessary.

Belt Spec: MXV4-370

Part# B08911

Service Adjustments