Manualshelf

Warranty

ManualsBrandsSnow Beast ManualsGas Snow Blowers30 in. Commercial 302 cc Electric Start 2-Stage Gas Snow Blower with Headlights, Bonus Drift Cutters and Clean-Out Tool
11121314151617181920
9
30SB, 36SB, 45SB
Snow BEAST
Snow BEAST Snow Blower
Rev Sept 2019
Assembly Instructions
Step 1: Control Panel Handles
1. Align the two holes on each side of the control panel
handles over the lower handle frame.
2. Insert the bolts through the handlebar holes and frame
holes. Secure in place with hardware provided. All bolt
heads must face to the inside.
3. Connect the headlight wring harness to the engine
Wiring harness.
Step 3: Chute Crank
Attach the cable coming from the middle of the
control panel by screwing the cable end onto the
crank section.
Bolt installed bottom-up
Step 2: Directional Discharge Chute
1. Fit round spacer onto impeller housing before installing chute.
2. Install the bolts for the retainer brackets bottom-up as shown.
Insert the plastic spacer between the two metal parts.
DO NOT OVERTIGHTEN. If the bracket is too tight the chute
will not move properly. Ensure there is enough space
between the impeller housing and the bracket on all sides
so that the chute rotates smoothly.