User guide

6. Controls
■
Controls Description
This chapter shows the controls at the ground
control box and the platform control box, and
explains what each control does.
This chapter DOES NOT explain how to use
the controls to produce useful work.
“Operation” chapter 8, covers the proper use
of controls.
See the “Emergency Operation” chapter 9, for
correct emergency operation procedures.
See the “Options” chapter 11, for correct
operation procedures of any optional equipment.
The main operating functions of an AB46J can be
controlled from the ground control box or from the
platform control box.
The names of the different controls on the ground
control box are shown on a decal next to the box.
The decal also shows the names of the different
settings to which each control can be set.
The names of the controls on the platform control
box are shown on a decal to the right of the box,
on the platform corner post. The decal also
shows the names of the different switch settings.
The Electronic Display automatically turns on
when platform control is selected, and displays
messages about the status of the drive system.
AB46J – 0163187 page 6 - 1
Ground Controls Decal
Platform Controls Decal
(inside platform post)
Ground Controls
Platform Controls
❑
Controls and Control Decals Locations
The Emergency Stop switch MUST be On
(pulled up) for the platform control box Electronic
Display to show messages.
After initial system diagnostics check, the system
will display a message that the system is "OK!
Depress platform foot switch to test battery.
Drive System is operable, only after the
"NEUTRAL VEL = 0.0 MPH" message is
displayed provided batteries have sufficient
charge for operation.
DRIVE SYSTEM CHECK
***SYSTEM OK!***
❑
Electronic Display Window