Quick Start Guide

3
Plug the charger into a
240V AC mains socket
ON/OFF
switch
Plug the charger
cable into the
socket on the
back of the Syrius
2. Charging the internal battery
Although the Syrius can be charged using the cigarette
lighter in your vehicle, a complete charge is more easily
achieved by using the 240V AC mains charger included.
When new, the battery in your Syrius is approximately
20% charged.
To charge the unit fully, push the ‘Batt. ON/OFF’
switch to the ‘OFF’ position and connect the
240V AC mains charger as indicated in the picture
on the right. Syrius will take approximately 3 hours
to charge. When the internal battery is fully charged
the orange LED will turn green. Once fully charged
the battery will last approximately 3 hrs during normal
use.
Note: The new battery’s full performance is only achieved
after two or three complete charges and discharges.
3. Powering Syrius using the built-in battery
Once Syrius has been fully charged it is ready for use. Push the ‘Batt. ON/OFF’ switch to
the ‘ON’ position and press and hold the standby/power switch on the left hand side of
the unit for 2 seconds to switch on the device.
WARNING: PLEASE DO NOT USE OR
LEAVE THE SYRIUS IN EITHER WET OR
HUMID CONDITIONS, OR IN EXTREME
TEMPERATURES, AS THIS COULD
PERMANENTLY DAMAGE THE UNIT
AND THE BATTERY. WHEN NOT IN USE
DO NOT LEAVE THE UNIT ATTACHED
TO THE WINDSCREEN, ESPECIALLY
WHEN THE WEATHER IS WARM, TO
AVOID DAMAGE TO THE UNIT AND
ALSO REDUCE THE RISK OF THEFT.