Quick Start Guide

QUICK START GUIDE

To utilise the Enigma Safety Camera database you will need to register your Syrius and

perform a download. Please refer to ‘Registering your Syrius’, ‘System Requirements

and Software Installation’ later in this Quick Start Guide for further information.

Start Up

1. Installing the SD Card

Before using your Syrius you will need to install the SD Card included with the device. The

SD Card comes complete with a digital map of the UK and Ireland or Western Europe

depending on the model purchased and is also where the Enigma

camera database is

stored if you choose to download it.

Start by pushing the ‘Batt. ON/OFF’ switch located on the underside of the unit to the ‘ON’

position, then remove the SD card from its packaging and insert it into the SD Card slot as

indicated. Finally switch on the device by pressing and holding the standby power button

located on the left hand side of the unit for 2 seconds. As soon as the device is switched

on the Syrius will automatically synchronise

with the SD Card. Once the synchronisation

is complete the SD Card will not function

with any other device. Your Syrius is now

ready to navigate and the camera database

can be downloaded if necessary.

Please note that if the unit does not

turn on when you press and hold the

standby power button for 2 seconds it

may require charging. Refer to the

section on ‘Power Connection and

Charging’ in the user manual located

on the CD ROM.

SD Card