Operation Manual

UK • 6
Return to contents
If the device does not power up please check that the cigarette lighter socket is clean of any debris, remembering not to insert metal
objects into the socket. Check that the cigarette lighter adaptor is inserted all the way into the socket and check that the fuse in the
cigarette lighter adaptor is operational. If My-Speed will still not power up, please check that the cigarette lighter in your vehicle is
functioning correctly.
Installation Troubleshooting
Replacing the Fuse
If My-Speed does not switch on the fuse in the cigarette lighter plug may have blown. To ascertain if the fuse has blown, follow the
steps below and if necessary replace it with a 2 amp, 5 x 20mm fast acting fuse.
Caution: Using a fuse that does not meet these ratings or defeating
fuse protection can damage your unit, the power cable, or the vehicles
electrical system.
1. Grasp the ring near the tip of the cigarette lighter plug, and then carefully
unscrew the ring by turning it counter clockwise.
Caution: If you must use pliers to loosen the ring, be careful not to
crush the tip. Never use pliers orother tools to retighten the ring on the
cigarette lighter plug.
2. Pull the ring straight out, then remove the metal tip and old fuse.
3. Check the fuse to see if it has blown. If it has, replace it.
4. Replace the metal tip inside the ring, then place the fuse inside the cigarette lighter plug and screw the ring back onto the plug.
Make sure the metal tip is visible when you reassemble the cigarette lighter plug.